Appalachian Mountains

From Citizendium
Jump to navigation Jump to search
This article is a stub and thus not approved.
Main Article
Discussion
Related Articles  [?]
Bibliography  [?]
External Links  [?]
Citable Version  [?]
 
This editable Main Article is under development and subject to a disclaimer.
The southernmost end of the Appalachians lies in Alabama, crossing portions of 15 other U.S. states and several Canadian provinces to end at Newfoundland and Labrador.

The Appalachian Mountains are a chain of mountains found in North America extending for almost 2,000 miles (3,200 km) from central Alabama in the United States to the Canadian province of Newfoundland and Labrador. The chain runs parallel to the Atlantic Ocean, though inland by up to a hundred miles (give or take) from the Atlantic coast.

Medium sized, but rugged and bunched up

The Appalachian mountain chain formed approximately 500 million years ago through the collision of continental plates. Older than the Rocky Mountains or the Himalayas, the Appalachians are nowhere near as high and may not seem imposing, but their rugged, steep, bunched-up formations are typically at around 5000' or higher[1], and they formed a barrier to European settlers hoping to move west in the early days of the United States.

Only one way through for early European settlers

The wilderness road leading to Cumberland Gap was the only way to get wagons through the Appalachian mountains in colonial times.

For European settlers trying to go west starting anywhere from North Carolina to New Jersey, there were two southwest-to-northeast mountain ridges that had to be crossed: the Cumberland Mountain ridge (more westerly) and the Pine Mountain ridge (more easterly). There were two gaps across Cumberland Mountain, at either Pennington Gap (Virginia) or, about 40 miles southward, Cumberland Gap. However, there is no easy way across the easterly Pine mountain ridge in the vicinity of Pennington Gap. Thus, Cumberland Gap became the only feasible way through for wagon trains, and in 1775, Daniel Boone led an expedition to blaze a trail across the Cumberland Gap.[2] Cumberland Gap became a famous place and is today the meeting point of three states, Tennessee, Virginia, and Kentucky.

Forty years later (and much farther north), a second, more practical route across the Appalachians was developed when the Erie Canal was built through the Mohawk Valley, across New York state to Buffalo, New York, at the eastern tip of Lake Erie.

Appalachian Trail

In the United Stated, a well-maintained, continuous hiking trail exists along the rim of the Appalachian mountains from Springer Mountain, Georgia to Mount Katahdin, Maine. This iconic, 2200-mile trail is used annually by around 3 million people, and about 3000 people attempt to hike it completely in one season beginning from Georgia in early spring; only about a quarter of those are able to complete the entire trail continuously in one season. It is generally considered a challenging route, requiring five to seven months to complete.

Strip mining and mountaintop removal

Mountaintop removal and strip mining for coal in the Appalachian mountains of Kentucky.

In modern times, much of the Appalachian chain, especially in Kentucky, Virginia, and Pennsylvania, has been subject to surface mining and mountaintop removal, usually for coal. In many cases, all it took was a bulldozer and a dump truck. Strip mines and mountaintop removals leave unsightly, erosion-prone areas with no top soil, unable to grow plants, and typically not remediated unless forced to by the government. This surface mining and mountaintop coal removal has been done because it's cheap and easy, and the quick profits from it can then be used to fund deeper, more costly shaft and drift mines.

References

  1. The highest peak in the Appalachians is Mount Mitchell in North Carolina at 6,684 feet above sea level.
  2. See The Cumberland Gap on danielboonetrail.com for more details.